Jenn-Air JDTSS244GP 24 in Top Control Built-In Dishwasher with 42 dBA, Third Rack, and Sensor Wash F8E2 Error Fix: Drain Pump Motor Failure

Error code F8E2 on the Jenn-Air JDTSS244GP 24 in Top Control Built-In Dishwasher with 42 dBA, Third Rack, and Sensor Wash means: Drain Pump Motor Failure. The drain pump motor is not running when energized or has failed mechanically — check the drain pump motor for continuity with a multimeter; verify the control board is sending voltage to the pump (approximately 120V AC when the drain cycle is active); if voltage is present but the pump does not run, the pump motor has failed and must be replaced; the drain pump is typically located at the bottom of the sump assembly

The most successful fix is "Test and Replace the Drain Pump Motor" (hard difficulty, ~60 minutes). Estimated DIY cost: $15-$25. HomeMD has 2 community-ranked fixes for this error.

This error is rated medium severity. It should be addressed soon, but your appliance may still function in a limited capacity.

Yes — the top-ranked community fix ("Test and Replace the Drain Pump Motor") is rated hard difficulty and takes about 60 minutes. Tools needed: T20 Torx screwdriver, Multimeter, Needle-nose pliers.

DIY cost: $15-$25. Professional repair typically costs $120-$200. Many homeowners save money by trying the top-ranked community fix first.

The Jenn-Air JDTSS244GP 24 in Top Control Built-In Dishwasher with 42 dBA, Third Rack, and Sensor Wash has 8 other known error codes, including: F1E1 (Temperature Sensor Failure), F1E2 (Temperature Sensor Shorted), F2E1 (Stuck Button / User Interface Error), F2E2 (User Interface Board Failure), F3E1 (Wash Pump Motor Not Running), and 3 more.

Error code F8E2 also appears on 1 other Jenn-Air model: JDB9200CWS 24 in TriFecta Dishwasher with 44 dBA, Steam Clean, and WiFi Connectivity. The fix may vary by model, so check each model's specific page for tailored repair steps.