F1E1
Jenn-Air · JDTSS244GP 24 in Top Control Built-In Dishwasher with 42 dBA, Third Rack, and Sensor Wash
The water temperature sensor (thermistor/NTC) has failed or is reading out of range — the sensor should read approximately 50K ohms at 77°F (25°C) and its resistance changes predictably with temperature; check the sensor wiring and connector on the main control board; if the wiring is intact, replace the temperature sensor; an out-of-range sensor prevents the dishwasher from properly regulating water temperature for wash and sanitize cycles
Error F1E1 on the Jenn-Air JDTSS244GP 24 in Top Control Built-In Dishwasher with 42 dBA, Third Rack, and Sensor Wash means: Temperature Sensor Failure. The top-ranked community fix is “Test and Replace the Temperature Sensor” (medium difficulty, ~45 min, DIY cost: $15-$25). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · dishwasher
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many dishwasher repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $120-$200.
dishwasher · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
Temperature Sensor Shorted
Stuck Button / User Interface Error
User Interface Board Failure
Wash Pump Motor Not Running
Wash Pump Motor Overcurrent
Wash Pump Motor Stalled
Door Switch / Latch Error
Door Switch Stuck Closed
The Jenn-Air JDTSS244GP 24 in Top Control Built-In Dishwasher with 42 dBA, Third Rack, and Sensor Wash has 8 other known error codes:
Error code F1E1 also appears on 5 other Jenn-Air models:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx