F1E2
Jenn-Air · JDTSS244GP 24 in Top Control Built-In Dishwasher with 42 dBA, Third Rack, and Sensor Wash
The thermistor circuit is shorted — reading near 0 ohms instead of the expected 50K ohm range; may be caused by a pinched wire where the harness passes through a panel, water damage at the sensor connector, or a failed sensor element; disconnect the sensor and measure its resistance directly; if shorted, replace the sensor; if the sensor reads normally when disconnected, the wiring harness has a short that must be repaired
Error F1E2 on the Jenn-Air JDTSS244GP 24 in Top Control Built-In Dishwasher with 42 dBA, Third Rack, and Sensor Wash means: Temperature Sensor Shorted. The top-ranked community fix is “Test Sensor and Wiring Harness for Shorts and Replace Faulty Parts” (medium difficulty, ~60 min, DIY cost: $15-$30). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · dishwasher
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many dishwasher repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $130-$220.
dishwasher · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
Temperature Sensor Failure
Stuck Button / User Interface Error
User Interface Board Failure
Wash Pump Motor Not Running
Wash Pump Motor Overcurrent
Wash Pump Motor Stalled
Door Switch / Latch Error
Door Switch Stuck Closed
The Jenn-Air JDTSS244GP 24 in Top Control Built-In Dishwasher with 42 dBA, Third Rack, and Sensor Wash has 8 other known error codes:
Error code F1E2 also appears on 5 other Jenn-Air models:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx