F1E2
Jenn-Air · JJW2830IM Wall Oven 30 in 4.1 cu ft Single Wall Oven with True Convection and Self-Clean
The oven control board's internal safety relay did not pass its self-test — the safety relay is designed to disconnect power to the heating elements if the main control relay fails; if the safety relay itself fails, the oven will not operate as a protective measure; this is a CRITICAL safety feature; the EOC board must be replaced; do not attempt to bypass the safety relay system
Error F1E2 on the Jenn-Air JJW2830IM Wall Oven 30 in 4.1 cu ft Single Wall Oven with True Convection and Self-Clean means: Safety Relay Test Failed. The top-ranked community fix is “Replace the Oven Electronic Control Board Due to Safety Relay Failure” (hard difficulty, ~90 min, DIY cost: $10-$20). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · oven
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many oven repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $250-$350.
dishwasher · 2 fixes
dishwasher · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
EEPROM Communication Error
EEPROM Checksum Error
Model ID / Configuration Mismatch
Calibration Data Shifted or Corrupt
Shorted Keypad / Touch Interface
Keypad Cable Disconnected
Cancel Key Short
Oven Temperature Sensor Open
The Jenn-Air JJW2830IM Wall Oven 30 in 4.1 cu ft Single Wall Oven with True Convection and Self-Clean has 8 other known error codes:
Error code F1E2 also appears on 5 other Jenn-Air models:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx