Electrolux EI24ID50QS 24 in Built-In Dishwasher with IQ-Touch Controls 44 dBA i60 Error Fix: Heating Element Fault — Water Not Heating

Error code i60 on the Electrolux EI24ID50QS 24 in Built-In Dishwasher with IQ-Touch Controls 44 dBA means: Heating Element Fault — Water Not Heating. The water heating system has failed. The dishwasher cannot heat the water to the required temperature for the selected cycle. Test the heating element for continuity with a multimeter — it should have a measurable resistance (typically 12-20 ohms). Check the water temperature sensor (thermistor/NTC) — its resistance should change with temperature (approximately 50K ohms at room temperature, decreasing as temperature rises). On Electrolux dishwashers, the heating element is often integrated into the sump assembly. Check the wiring connections to the heater and thermistor.

The most successful fix is "Test and Replace Heating Element and Thermistor Assembly" (hard difficulty, ~90 minutes). Estimated DIY cost: $50-$80. HomeMD has 2 community-ranked fixes for this error.

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Yes — the top-ranked community fix ("Test and Replace Heating Element and Thermistor Assembly") is rated hard difficulty and takes about 90 minutes. Tools needed: T20 Torx screwdriver, Multimeter, Flashlight, Pliers.

DIY cost: $50-$80. Professional repair typically costs $250-$400. Many homeowners save money by trying the top-ranked community fix first.

The Electrolux EI24ID50QS 24 in Built-In Dishwasher with IQ-Touch Controls 44 dBA has 8 other known error codes, including: ER:01 (Wash Motor Stuck or Locked), i10 (Water Supply Issue — Not Filling), i20 (Drain Issue — Not Draining Properly), i30 (Leak Detected — Anti-Flood Activated), i50 (Drain Pump Short or Fault), and 3 more.