Electrolux EI24ID50QS 24 in Built-In Dishwasher with IQ-Touch Controls 44 dBA i10 Error Fix: Water Supply Issue — Not Filling

Error code i10 on the Electrolux EI24ID50QS 24 in Built-In Dishwasher with IQ-Touch Controls 44 dBA means: Water Supply Issue — Not Filling. The dishwasher is not receiving water or is filling too slowly. The fill timeout has been reached. Check that the household water supply valve under the sink is fully open. Inspect the water inlet hose for kinks. Remove the inlet hose from the dishwasher and clean the mesh filter screen at the water inlet valve — mineral deposits are the most common cause of slow filling. Verify household water pressure is at least 20 PSI. Test the water inlet valve solenoid for continuity. Replace the inlet valve if it does not open when energized.

The most successful fix is "Test and Replace Water Inlet Valve" (medium difficulty, ~60 minutes). Estimated DIY cost: $10-$15. HomeMD has 2 community-ranked fixes for this error.

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Yes — the top-ranked community fix ("Test and Replace Water Inlet Valve") is rated medium difficulty and takes about 60 minutes. Tools needed: T20 Torx screwdriver, Multimeter, Adjustable pliers, Towel.

DIY cost: $10-$15. Professional repair typically costs $150-$220. Many homeowners save money by trying the top-ranked community fix first.

The Electrolux EI24ID50QS 24 in Built-In Dishwasher with IQ-Touch Controls 44 dBA has 8 other known error codes, including: ER:01 (Wash Motor Stuck or Locked), i20 (Drain Issue — Not Draining Properly), i30 (Leak Detected — Anti-Flood Activated), i50 (Drain Pump Short or Fault), i60 (Heating Element Fault — Water Not Heating), and 3 more.