MECH-WONT-START
Craftsman · Craftsman B210 27cc 2-Cycle Gas Leaf Blower (210 MPH)
The gas leaf blower engine does not start. The Craftsman B210 uses a 27cc 2-cycle engine requiring fuel/oil mix. Starting procedure is the same as other Craftsman 2-cycle equipment: prime the bulb 5-7 times, set choke to FULL, pull until it pops, move choke to HALF, pull to start, then move to RUN. If it will not start: (1) Stale fuel — the #1 cause. Drain and replace with fresh 50:1 mix. (2) Flooded engine — if you smell fuel, set choke OFF, hold throttle wide open, and pull 10+ times. (3) Fouled spark plug — remove, inspect, replace if needed. (4) Clogged air filter — clean or replace. (5) Fuel filter clogged — replace the in-tank filter. (6) Carburetor varnished from old fuel — clean or rebuild. (7) Primer bulb cracked — if the primer does not firm up after pressing, it has a hole. Replace. (8) Spark arrestor clogged — carbon deposits restrict exhaust.
Error MECH-WONT-START on the Craftsman Craftsman B210 27cc 2-Cycle Gas Leaf Blower (210 MPH) means: Blower Engine Will Not Start. The top-ranked community fix is “Replace Spark Plug and Clean Carburetor” (medium difficulty, ~45 min, DIY cost: $10-$25). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · leaf blower
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many leaf blower repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $150-$220.
pressure_washer · 2 fixes
push_mower · 2 fixes
riding_mower · 2 fixes
riding_mower · 2 fixes
push_mower · 2 fixes
chainsaw · 2 fixes
riding_mower · 2 fixes
string_trimmer · 2 fixes
riding_mower · 2 fixes
The Craftsman Craftsman B210 27cc 2-Cycle Gas Leaf Blower (210 MPH) has 5 other known error codes:
Error code MECH-WONT-START also appears on 9 other Craftsman models:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx