A.O. Smith AHPTU-80 Voltex Hybrid 80 Gal 4500W Hybrid Heat Pump Water Heater with WiFi Connectivity E01 Error Fix: Upper Tank Sensor Failure

Error code E01 on the A.O. Smith AHPTU-80 Voltex Hybrid 80 Gal 4500W Hybrid Heat Pump Water Heater with WiFi Connectivity means: Upper Tank Sensor Failure. The upper tank temperature sensor has failed — open or short circuit detected. The heat pump control board cannot accurately monitor upper tank temperature. The heat pump mode may be disabled and the unit may fall back to electric-only operation. Disconnect power and check the sensor wire connections on the control board. Measure sensor resistance — should be approximately 10K ohms at room temperature. Replace the upper sensor if readings are abnormal.

The most successful fix is "Test and Replace Upper Tank Temperature Sensor" (medium difficulty, ~40 minutes). Estimated DIY cost: $15-$25. HomeMD has 2 community-ranked fixes for this error.

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Yes — the top-ranked community fix ("Test and Replace Upper Tank Temperature Sensor") is rated medium difficulty and takes about 40 minutes. Tools needed: Phillips screwdriver, Digital multimeter, Needle-nose pliers.

DIY cost: $15-$25. Professional repair typically costs $180-$260. Many homeowners save money by trying the top-ranked community fix first.

The A.O. Smith AHPTU-80 Voltex Hybrid 80 Gal 4500W Hybrid Heat Pump Water Heater with WiFi Connectivity has 8 other known error codes, including: E02 (Lower Tank Sensor Failure), E03 (Dry Fire / ECO Trip), E04 (Compressor Discharge Over-Temperature), E05 (Evaporator Coil Sensor Failure), E06 (Condenser Fan Motor Failure), and 3 more.

Error code E01 also appears on 1 other A.O. Smith model: HPTU-50N HE Hybrid 50 Gal 4500W High Efficiency Hybrid Heat Pump Water Heater. The fix may vary by model, so check each model's specific page for tailored repair steps.