👕Washer

F1E1

Amana · NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle

Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle F1E1 Error Fix: Main Control EEPROM Error

The main electronic control board has detected an EEPROM memory error — the stored program data is corrupted or unreadable. Disconnect power for 1 minute, then restore power to attempt a board reset. If the code returns immediately after restoring power, the main control board (CCU — Central Control Unit) must be replaced. Check the wiring harness connections at the CCU before replacing the board — a loose connector can cause communication errors that mimic EEPROM failures.

High severity2 fixes available✨ Free fix available

Quick Answer

Error F1E1 on the Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle means: Main Control EEPROM Error. The top-ranked community fix is “Inspect Wiring and Replace Main Control Board (CCU)” (hard difficulty, ~90 min, DIY cost: $20-$30). 2 community-ranked fixes available below.

Published February 2026 · 2 fixes · washer

Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.

When to Call a Professional

While many washer repairs can be done safely at home, consider hiring a qualified technician if:

This is a high severity error — continued use may cause damage or a safety hazard
The repair involves electrical wiring, gas lines, or refrigerant
You've tried the top-ranked fix and the error persists
You smell gas, see sparking, or notice water leaking
The repair requires specialized tools you don't have
Your appliance is still under manufacturer warranty

Average professional repair cost for this issue: $250-$350.

Other Amana Models with Error F1E1

NED5800HW 7.0 cu ft Electric Dryer with Wrinkle Prevent and Sensor Dry

dryer · 2 fixes

Other Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle Error Codes

Door Lock Failure

2 fixes

F0E2

Overloaded or Excessive Suds

2 fixes

F0E5

Off-Balance Load Detected

2 fixes

F1E2

Motor Control Unit Error

2 fixes

F3E1

Pressure Switch / Water Level Sensor Error

2 fixes

F3E2

Water Temperature Sensor Fault

Door Switch Error

Door Lock Error

People Also Ask About Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle Error F1E1

What does error code F1E1 mean on a Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle?

Error code F1E1 on the Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle means: Main Control EEPROM Error. The main electronic control board has detected an EEPROM memory error — the stored program data is corrupted or unreadable. Disconnect power for 1 minute, then restore power to attempt a board reset. If the code returns immediately after restoring power, the main control board (CCU — Central Control Unit) must be replaced. Check the wiring harness connections at the CCU before replacing the board — a loose connector can cause communication errors that mimic EEPROM failures.

How do I fix error code F1E1 on my Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle?

The most successful fix is "Inspect Wiring and Replace Main Control Board (CCU)" (hard difficulty, ~90 minutes). Estimated DIY cost: $20-$30. HomeMD has 2 community-ranked fixes for this error.

Is error code F1E1 on a Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle serious?

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Can I fix Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle error F1E1 myself?

Yes — the top-ranked community fix ("Inspect Wiring and Replace Main Control Board (CCU)") is rated hard difficulty and takes about 90 minutes. Tools needed: T20 Torx screwdriver, Multimeter, Electrical contact cleaner.

How much does it cost to repair Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle error F1E1?

DIY cost: $20-$30. Professional repair typically costs $250-$350. Many homeowners save money by trying the top-ranked community fix first.

What other error codes does the Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle have?

The Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle has 8 other known error codes, including: dL (Door Lock Failure), F0E2 (Overloaded or Excessive Suds), F0E5 (Off-Balance Load Detected), F1E2 (Motor Control Unit Error), F3E1 (Pressure Switch / Water Level Sensor Error), and 3 more.

Which other Amana models have the F1E1 error?

Error code F1E1 also appears on 1 other Amana model: NED5800HW 7.0 cu ft Electric Dryer with Wrinkle Prevent and Sensor Dry. The fix may vary by model, so check each model's specific page for tailored repair steps.

What other error codes does the Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle have?

The Amana NFW5800HW 4.3 cu ft Front Load Washer with Steam and Sanitize Cycle has 8 other known error codes:

dL — Door Lock Failure (2 fixes)
F0E2 — Overloaded or Excessive Suds (2 fixes)
F0E5 — Off-Balance Load Detected (2 fixes)
F1E2 — Motor Control Unit Error (2 fixes)
F3E1 — Pressure Switch / Water Level Sensor Error (2 fixes)
F3E2 — Water Temperature Sensor Fault (2 fixes)
F5E1 — Door Switch Error (2 fixes)
F5E2 — Door Lock Error (2 fixes)

Which other Amana models have the F1E1 error?

Error code F1E1 also appears on 1 other Amana model:

NED5800HW 7.0 cu ft Electric Dryer with Wrinkle Prevent and Sensor Dry (dryer) · 2 fixes

Ad Space — banner

Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx