KitchenAid KWTW4815EW 3.8 cu. ft. Top Load Washer with Removable Agitator F3E2 Error Fix: Water Level Sensor Calibration Error

Error code F3E2 on the KitchenAid KWTW4815EW 3.8 cu. ft. Top Load Washer with Removable Agitator means: Water Level Sensor Calibration Error. The pressure sensor reading does not match the expected calibration values. May occur after a sensor or control board replacement without proper calibration. Run the calibration procedure per the service manual. If calibration fails, the pressure sensor may need replacement.

The most successful fix is "Replace and Calibrate the Water Level Pressure Sensor" (medium difficulty, ~60 minutes). Estimated DIY cost: $25-$35. HomeMD has 2 community-ranked fixes for this error.

This error is rated medium severity. It should be addressed soon, but your appliance may still function in a limited capacity.

Yes — the top-ranked community fix ("Replace and Calibrate the Water Level Pressure Sensor") is rated medium difficulty and takes about 60 minutes. Tools needed: T20 Torx screwdriver, Needle-nose pliers, Flashlight.

DIY cost: $25-$35. Professional repair typically costs $130-$200. Many homeowners save money by trying the top-ranked community fix first.

The KitchenAid KWTW4815EW 3.8 cu. ft. Top Load Washer with Removable Agitator has 8 other known error codes, including: AGITATOR NOT MOVING (Agitator Not Moving), F0E1 (Motor Control Board Error (MCU)), F0E2 (MCU Communication Failure), F0E5 (Motor Stall Detected), F1E1 (Main Control Board Fault), and 3 more.

Error code F3E2 also appears on 5 other KitchenAid models: KDFE104HPS 46 dBA Front Control Dishwasher with PrintShield Finish, KDTE204KPS 39 dBA Top Control Dishwasher with Third Level Utensil Rack, KFEG500ESS 30 in. 5-Element Electric Convection Slide-In Range, KFGD500ESS 30 in. 5-Burner Gas Convection Slide-In Range, KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection. The fix may vary by model, so check each model's specific page for tailored repair steps.