F3E2
Jenn-Air · JJW2830IM Wall Oven 30 in 4.1 cu ft Single Wall Oven with True Convection and Self-Clean
The oven temperature has exceeded the maximum safe threshold — approximately 665°F in bake mode or 990°F in self-clean; this is a POTENTIALLY DANGEROUS condition; turn off the oven immediately and disconnect power at the breaker; the most common cause is a stuck/welded bake or broil relay on the EOC board — the relay contacts fused closed, providing continuous power to the heating element even when the control commands it off; check the oven sensor accuracy; if a relay is stuck, the EOC MUST be replaced immediately — a stuck relay is a fire hazard
Error F3E2 on the Jenn-Air JJW2830IM Wall Oven 30 in 4.1 cu ft Single Wall Oven with True Convection and Self-Clean means: Oven Over-Temperature (Runaway). The top-ranked community fix is “Replace the Oven Electronic Oven Control (EOC) Board” (hard difficulty, ~60 min, DIY cost: $15-$25). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · oven
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many oven repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $200-$350.
dishwasher · 2 fixes
dishwasher · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
EEPROM Communication Error
EEPROM Checksum Error
Safety Relay Test Failed
Model ID / Configuration Mismatch
Calibration Data Shifted or Corrupt
Shorted Keypad / Touch Interface
Keypad Cable Disconnected
Cancel Key Short
The Jenn-Air JJW2830IM Wall Oven 30 in 4.1 cu ft Single Wall Oven with True Convection and Self-Clean has 8 other known error codes:
Error code F3E2 also appears on 5 other Jenn-Air models:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx