F3E1
Jenn-Air · JJW2830IM Wall Oven 30 in 4.1 cu ft Single Wall Oven with True Convection and Self-Clean
The oven sensor circuit reads shorted — near 0 ohms indicates the sensor element has failed short or the wiring conductors are touching; disconnect the sensor connector and measure resistance at the sensor leads; if near 0 ohms, replace the sensor; if the sensor reads normally (~1,080 ohms at room temp), check the harness for pinched wires where the conductors may be contacting each other or the metal oven frame; insulation damage from heat is a common cause
Error F3E1 on the Jenn-Air JJW2830IM Wall Oven 30 in 4.1 cu ft Single Wall Oven with True Convection and Self-Clean means: Oven Temperature Sensor Shorted. The top-ranked community fix is “Replace Oven Temperature Sensor and Repair Wiring Harness” (hard difficulty, ~60 min, DIY cost: $25-$40). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · oven
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many oven repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $150-$220.
dishwasher · 2 fixes
dishwasher · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
EEPROM Communication Error
EEPROM Checksum Error
Safety Relay Test Failed
Model ID / Configuration Mismatch
Calibration Data Shifted or Corrupt
Shorted Keypad / Touch Interface
Keypad Cable Disconnected
Cancel Key Short
The Jenn-Air JJW2830IM Wall Oven 30 in 4.1 cu ft Single Wall Oven with True Convection and Self-Clean has 8 other known error codes:
Error code F3E1 also appears on 5 other Jenn-Air models:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx