Frigidaire Frigidaire FGID2468UF 24 in Gallery Integrated Built-In Dishwasher with OrbitClean Wash System Er-13 Error Fix: Electronic Control Board Failure

Error code Er-13 on the Frigidaire Frigidaire FGID2468UF 24 in Gallery Integrated Built-In Dishwasher with OrbitClean Wash System means: Electronic Control Board Failure. The electronic control board has failed. The main control board manages all dishwasher functions including wash cycles, water fill, heating, and draining. Try resetting the dishwasher by turning off power at the circuit breaker for 5 minutes. Check all wire harness connections to the board. Look for signs of damage, burned components, or water damage on the board. Replace the electronic control board if it is defective.

The most successful fix is "Replace the Electronic Control Board" (hard difficulty, ~60 minutes). Estimated DIY cost: $15-$20. HomeMD has 2 community-ranked fixes for this error.

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Yes — the top-ranked community fix ("Replace the Electronic Control Board") is rated hard difficulty and takes about 60 minutes. Tools needed: T20 Torx screwdriver, Needle-nose pliers, Multimeter.

DIY cost: $15-$20. Professional repair typically costs $200-$350. Many homeowners save money by trying the top-ranked community fix first.

The Frigidaire Frigidaire FGID2468UF 24 in Gallery Integrated Built-In Dishwasher with OrbitClean Wash System has 8 other known error codes, including: Er-01 (Water Leak Detected), Er-02 (Thermistor/Turbidity Sensor Failure), Er-03 (Wash Motor Failure), Er-04 (Upper Fan/Vent Failure), Er-05 (Upper Vent Failure), and 3 more.

Error code Er-13 also appears on 2 other Frigidaire models: FFCD2413US 24 in Built-In Dishwasher 60 dBA, FFCD2418US 24 in Front Control Built-In Dishwasher 48 dBA. The fix may vary by model, so check each model's specific page for tailored repair steps.