Bosch WGG244ABUS 2.4 cu ft 500 Series Smart Washer E02 Error Fix: Motor / Inverter Fault

Error code E02 on the Bosch WGG244ABUS 2.4 cu ft 500 Series Smart Washer means: Motor / Inverter Fault. The motor or motor inverter (variable frequency drive) has failed. The control cannot drive the drum motor to the required speed. Check the motor wiring harness for loose connections. Inspect the motor control board (inverter) for burn marks or damaged components. The inverter is usually a separate board from the main control. If the drum turns freely by hand but the motor will not run, the inverter or motor may need replacement. Check the motor hall sensor.

The most successful fix is "Test and Replace Motor Hall Sensor or Motor Inverter Board" (hard difficulty, ~90 minutes). Estimated DIY cost: $15-$30. HomeMD has 2 community-ranked fixes for this error.

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Yes — the top-ranked community fix ("Test and Replace Motor Hall Sensor or Motor Inverter Board") is rated hard difficulty and takes about 90 minutes. Tools needed: T20 Torx screwdriver, Multimeter, Needle-nose pliers.

DIY cost: $15-$30. Professional repair typically costs $200-$350. Many homeowners save money by trying the top-ranked community fix first.

The Bosch WGG244ABUS 2.4 cu ft 500 Series Smart Washer has 8 other known error codes, including: E13 (Water Inlet Timeout), E17 (Overfill Condition), E18 (Drain Timeout), E23 (AquaStop / Leak Detected), E29 (Door Lock / Interlock Fault), and 3 more.

Error code E02 also appears on 4 other Bosch models: WGA242ABUS 2.4 cu ft 500 Series Compact Front-Load Washer, WGA244ABUS 2.4 cu ft 500 Series Compact Washer, WGA244AMUS 2.4 cu ft 500 Series Washer White, WGA252ABUS 2.4 cu ft 500 Series with Home Connect. The fix may vary by model, so check each model's specific page for tailored repair steps.