Amana ADB1400AGS 24 in Front Control Dishwasher 50 dBA Quiet Wash Cycle Clean+Start Flash Error Fix: Clean and Start Lights Flashing Together — Control Reset Needed

Error code Clean+Start Flash on the Amana ADB1400AGS 24 in Front Control Dishwasher 50 dBA Quiet Wash Cycle means: Clean and Start Lights Flashing Together — Control Reset Needed. Both the Clean and Start indicator lights are flashing simultaneously. This indicates the control board needs to be reset. Disconnect power to the dishwasher at the breaker for 1 minute, then restore power. If the lights continue flashing after the reset, the main control board may have a hardware fault and may need replacement. Check all wiring harness connections to the control board before replacing.

The most successful fix is "Inspect and Replace the Main Control Board" (hard difficulty, ~60 minutes). Estimated DIY cost: $10-$20. HomeMD has 2 community-ranked fixes for this error.

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Yes — the top-ranked community fix ("Inspect and Replace the Main Control Board") is rated hard difficulty and takes about 60 minutes. Tools needed: T20 Torx screwdriver, Voltage tester.

DIY cost: $10-$20. Professional repair typically costs $200-$300. Many homeowners save money by trying the top-ranked community fix first.

The Amana ADB1400AGS 24 in Front Control Dishwasher 50 dBA Quiet Wash Cycle has 7 other known error codes, including: 1-Blink (Clean Light 1 Blink — Door Not Latched), 2-Blink (Clean Light 2 Blinks — Drain Issue), 3-Blink (Clean Light 3 Blinks — Water Temperature Issue), 4-Blink (Clean Light 4 Blinks — Water Fill Error), 7-Blink (Clean Light 7 Blinks — Sensor or Flow Error), and 2 more.

Error code Clean+Start Flash also appears on 1 other Amana model: ADB1700ADS Tall Tub DW. The fix may vary by model, so check each model's specific page for tailored repair steps.