Whirlpool Whirlpool WFE775H0HZ 6.4 cu. ft. Smart Slide-In Electric Range F1E4 Error Fix: Model Configuration Error

Error code F1E4 on the Whirlpool Whirlpool WFE775H0HZ 6.4 cu. ft. Smart Slide-In Electric Range means: Model Configuration Error. The control board's stored model/serial configuration does not match the appliance it is installed in. This can happen if a replacement control board was programmed for a different model or if the EEPROM data has become corrupted. On some Whirlpool ovens, a service technician can reprogram the configuration via a service mode. Otherwise, the board must be exchanged for one properly matched to the model.

The most successful fix is "Reprogram or Replace the Control Board with Correct Model Configuration" (hard difficulty, ~90 minutes). Estimated DIY cost: $0-$15. HomeMD has 2 community-ranked fixes for this error.

This error is rated info severity. It is generally not urgent and can often be resolved with a simple DIY fix.

Yes — the top-ranked community fix ("Reprogram or Replace the Control Board with Correct Model Configuration") is rated hard difficulty and takes about 90 minutes. Tools needed: T20 Torx screwdriver, Multimeter, Service programming tool (optional).

DIY cost: $0-$15. Professional repair typically costs $250-$400. Many homeowners save money by trying the top-ranked community fix first.

The Whirlpool Whirlpool WFE775H0HZ 6.4 cu. ft. Smart Slide-In Electric Range has 8 other known error codes, including: F1E0 (EEPROM Communication Error), F1E1 (Control Board Internal Fault), F2E0 (Shorted Keypad/Touchpad), F2E1 (Keypad Connection Error), F3E0 (Oven Temperature Sensor Open), and 3 more.

Error code F1E4 also appears on 2 other Whirlpool models: Whirlpool WFG505M0BS 5.0 cu. ft. Freestanding Gas Range, Whirlpool WOS51EC0HS 5.0 cu. ft. Single Wall Oven. The fix may vary by model, so check each model's specific page for tailored repair steps.