Speed Queen DG7004WG 7.0 cu ft Gas Dryer with Stainless Steel Drum and Sensor Dry Technology E20 Error Fix: Motor Relay Stuck

Error code E20 on the Speed Queen DG7004WG 7.0 cu ft Gas Dryer with Stainless Steel Drum and Sensor Dry Technology means: Motor Relay Stuck. The motor relay on the control board is stuck in the closed position, causing the motor to run continuously or preventing it from starting properly. This may cause overheating and damage.

The most successful fix is "Replace Control Board" (hard difficulty, ~60 minutes). Estimated DIY cost: $150-$250. HomeMD has 2 community-ranked fixes for this error.

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Yes — the top-ranked community fix ("Replace Control Board") is rated hard difficulty and takes about 60 minutes. Tools needed: Phillips screwdriver, Nut driver.

DIY cost: $150-$250. Professional repair typically costs $400-$600. Many homeowners save money by trying the top-ranked community fix first.

The Speed Queen DG7004WG 7.0 cu ft Gas Dryer with Stainless Steel Drum and Sensor Dry Technology has 8 other known error codes, including: E01 (Thermistor Open Circuit), E02 (Thermistor Short Circuit), E03 (Ignition Failure), E04 (High Limit Thermostat Open), E05 (Door Switch Fault), and 3 more.

Error code E20 also appears on 5 other Speed Queen models: DC5003WE 7.0 cu ft Classic Electric Dryer with Stainless Steel Drum and 5 Temperature Settings, DF7004WE 8.0 cu ft Large Capacity Electric Dryer with Wrinkle Prevent and Heavy Duty Cycles, DR5004WE 7.0 cu ft Electric Stack Dryer with Heavy Duty Cycles and Stainless Steel Drum, FF7009SN 3.2 cu ft Front Load Washer with Stainless Steel Drum and 12 Wash Cycles, TC5003WN 3.2 cu ft Classic Clean Top Load Washer with Stainless Steel Tub and 6 Wash Cycles. The fix may vary by model, so check each model's specific page for tailored repair steps.