🔥Oven / Range

ELEMENT BURNED OUT

KitchenAid · KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection

KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection ELEMENT BURNED OUT Error Fix: Bake or Broil Element Burned Out (Electric)

The electric bake (bottom) or broil (top) heating element has a visible burn-through hole, blister, or break. The element may arc or spark at the failure point. Disconnect power and inspect both elements. Replace the element — they are held by 2 screws and a wiring connector at the rear. Element resistance should be ~20-50 ohms.

High severity2 fixes available✨ Free fix available

Quick Answer

Error ELEMENT BURNED OUT on the KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection means: Bake or Broil Element Burned Out (Electric). The top-ranked community fix is “Replace the Burned Out Bake or Broil Element” (medium difficulty, ~45 min, DIY cost: $15-$25). 2 community-ranked fixes available below.

Published February 2026 · 2 fixes · oven

Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.

When to Call a Professional

While many oven repairs can be done safely at home, consider hiring a qualified technician if:

This is a high severity error — continued use may cause damage or a safety hazard
The repair involves electrical wiring, gas lines, or refrigerant
You've tried the top-ranked fix and the error persists
You smell gas, see sparking, or notice water leaking
The repair requires specialized tools you don't have
Your appliance is still under manufacturer warranty

Average professional repair cost for this issue: $120-$180.

Other KitchenAid Models with Error ELEMENT BURNED OUT

KFEG500ESS 30 in. 5-Element Electric Convection Slide-In Range

oven · 2 fixes

KFGD500ESS 30 in. 5-Burner Gas Convection Slide-In Range

oven · 2 fixes

Other KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection Error Codes

BURNER WON'T LIGHT

Surface Burner Continuous Sparking (Gas Only)

2 fixes

DOOR NOT CLOSING

Oven Door Not Closing Flush

2 fixes

F1E0

EEPROM Communication Error

2 fixes

F1E1

EEPROM Checksum Error

2 fixes

F1E2

Safety Relay Test Failed

2 fixes

F2E0

Shorted Keypad / Touch Interface

2 fixes

F2E1

Keypad Cable Disconnected

2 fixes

F2E5

Cancel Key Shorted

2 fixes

People Also Ask About KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection Error ELEMENT BURNED OUT

What does error code ELEMENT BURNED OUT mean on a KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection?

Error code ELEMENT BURNED OUT on the KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection means: Bake or Broil Element Burned Out (Electric). The electric bake (bottom) or broil (top) heating element has a visible burn-through hole, blister, or break. The element may arc or spark at the failure point. Disconnect power and inspect both elements. Replace the element — they are held by 2 screws and a wiring connector at the rear. Element resistance should be ~20-50 ohms.

How do I fix error code ELEMENT BURNED OUT on my KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection?

The most successful fix is "Replace the Burned Out Bake or Broil Element" (medium difficulty, ~45 minutes). Estimated DIY cost: $15-$25. HomeMD has 2 community-ranked fixes for this error.

Is error code ELEMENT BURNED OUT on a KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection serious?

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Can I fix KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection error ELEMENT BURNED OUT myself?

Yes — the top-ranked community fix ("Replace the Burned Out Bake or Broil Element") is rated medium difficulty and takes about 45 minutes. Tools needed: Phillips screwdriver, Multimeter, Non-contact voltage tester.

How much does it cost to repair KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection error ELEMENT BURNED OUT?

DIY cost: $15-$25. Professional repair typically costs $120-$180. Many homeowners save money by trying the top-ranked community fix first.

What other error codes does the KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection have?

The KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection has 8 other known error codes, including: BURNER WON'T LIGHT (Surface Burner Continuous Sparking (Gas Only)), DOOR NOT CLOSING (Oven Door Not Closing Flush), F1E0 (EEPROM Communication Error), F1E1 (EEPROM Checksum Error), F1E2 (Safety Relay Test Failed), and 3 more.

Which other KitchenAid models have the ELEMENT BURNED OUT error?

Error code ELEMENT BURNED OUT also appears on 2 other KitchenAid models: KFEG500ESS 30 in. 5-Element Electric Convection Slide-In Range, KFGD500ESS 30 in. 5-Burner Gas Convection Slide-In Range. The fix may vary by model, so check each model's specific page for tailored repair steps.

What other error codes does the KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection have?

The KitchenAid KOSE500ESS 30 in. Single Wall Oven with Even-Heat True Convection has 8 other known error codes:

BURNER WON'T LIGHT — Surface Burner Continuous Sparking (Gas Only) (2 fixes)
DOOR NOT CLOSING — Oven Door Not Closing Flush (2 fixes)
F1E0 — EEPROM Communication Error (2 fixes)
F1E1 — EEPROM Checksum Error (2 fixes)
F1E2 — Safety Relay Test Failed (2 fixes)
F2E0 — Shorted Keypad / Touch Interface (2 fixes)
F2E1 — Keypad Cable Disconnected (2 fixes)
F2E5 — Cancel Key Shorted (2 fixes)

Which other KitchenAid models have the ELEMENT BURNED OUT error?

Error code ELEMENT BURNED OUT also appears on 2 other KitchenAid models:

KFEG500ESS 30 in. 5-Element Electric Convection Slide-In Range (oven) · 2 fixes
KFGD500ESS 30 in. 5-Burner Gas Convection Slide-In Range (oven) · 2 fixes

Ad Space — banner

Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx