KitchenAid KDFE104HPS 46 dBA Front Control Dishwasher with PrintShield Finish FEE1 Error Fix: Leak Detected — Water in Base Pan

Error code FEE1 on the KitchenAid KDFE104HPS 46 dBA Front Control Dishwasher with PrintShield Finish means: Leak Detected — Water in Base Pan. The leak sensor (float switch) in the base of the dishwasher has detected water. A float in the base pan has risen due to water accumulation. Check for leaks from the door gasket, spray arm connections, hose clamps, the sump/pump assembly, and the water inlet. Tilt the dishwasher slightly forward to drain the base pan. Identify and fix the leak source before resetting. The dishwasher will not operate until the base pan is dry.

The most successful fix is "Replace Leak Sensor Float Switch and Repair Leak Source" (hard difficulty, ~60 minutes). Estimated DIY cost: $15-$25. HomeMD has 2 community-ranked fixes for this error.

This error is rated high severity. You should address it promptly — continued use could cause damage or safety concerns.

Yes — the top-ranked community fix ("Replace Leak Sensor Float Switch and Repair Leak Source") is rated hard difficulty and takes about 60 minutes. Tools needed: T20 Torx screwdriver, Multimeter, Flashlight, Pliers.

DIY cost: $15-$25. Professional repair typically costs $120-$200. Many homeowners save money by trying the top-ranked community fix first.

The KitchenAid KDFE104HPS 46 dBA Front Control Dishwasher with PrintShield Finish has 8 other known error codes, including: DISPENSER STUCK (Detergent Dispenser Not Opening), DOOR GASKET LEAK (Door Gasket Leaking), F1E1 (Control Board Stuck Key), F1E2 (Control Board Memory Error), F2E1 (User Interface Stuck Key), and 3 more.

Error code FEE1 also appears on 1 other KitchenAid model: KDTE204KPS 39 dBA Top Control Dishwasher with Third Level Utensil Rack. The fix may vary by model, so check each model's specific page for tailored repair steps.