MECH-01
Jenn-Air · JMW2430IM 30 in Combination Microwave Wall Oven with True Convection
The gas oven igniter (hot surface igniter / glow bar) is weak or burned out — the igniter must draw sufficient amperage (typically 3.2-3.6 amps) to open the gas safety valve; a weak igniter glows orange/red but does not draw enough current to open the valve, so the oven does not light; symptoms include: gas smell without ignition, oven takes 15+ minutes to preheat, or oven does not heat at all; this is the single most common gas range repair; the igniter is located at the bottom of the oven cavity near the burner tube; replacement requires disconnecting the wire connector and removing 2 mounting screws; handle new igniters carefully as the silicon carbide element is fragile
Error MECH-01 on the Jenn-Air JMW2430IM 30 in Combination Microwave Wall Oven with True Convection means: Gas Oven Igniter Failure. The top-ranked community fix is “Replace the Gas Oven Igniter” (medium difficulty, ~45 min, DIY cost: $20-$30). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · oven
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many oven repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $180-$300.
refrigerator · 2 fixes
dishwasher · 2 fixes
dishwasher · 2 fixes
refrigerator · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
refrigerator · 2 fixes
EEPROM Communication Error
EEPROM Checksum Error
Safety Relay Test Failed
Model ID / Configuration Mismatch
Calibration Data Shifted or Corrupt
Shorted Keypad / Touch Interface
Keypad Cable Disconnected
Cancel Key Short
The Jenn-Air JMW2430IM 30 in Combination Microwave Wall Oven with True Convection has 8 other known error codes:
Error code MECH-01 also appears on 9 other Jenn-Air models:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx