Jandy ePump 2.7 THP Variable Speed Pool Pump with Digital Control CE Error Fix: Communication Error — RS-485 Link Lost

Error code CE on the Jandy ePump 2.7 THP Variable Speed Pool Pump with Digital Control means: Communication Error — RS-485 Link Lost. The pump lost RS-485 communication with the AquaLink RS controller — the pump continues to operate in standalone mode at its last programmed settings but cannot be controlled or monitored remotely; check RS-485 wiring between the pump and the AquaLink panel; look for loose, corroded, or water-damaged connections; verify correct wiring polarity; RS-485 bus issues are often intermittent and caused by moisture at connection points

The most successful fix is "Replace or Repair RS-485 Wiring and Connectors" (medium difficulty, ~45 minutes). Estimated DIY cost: $15-$25. HomeMD has 2 community-ranked fixes for this error.

This error is rated medium severity. It should be addressed soon, but your appliance may still function in a limited capacity.

Yes — the top-ranked community fix ("Replace or Repair RS-485 Wiring and Connectors") is rated medium difficulty and takes about 45 minutes. Tools needed: Multimeter, Wire strippers, Crimping tool, Phillips screwdriver.

DIY cost: $15-$25. Professional repair typically costs $120-$180. Many homeowners save money by trying the top-ranked community fix first.

The Jandy ePump 2.7 THP Variable Speed Pool Pump with Digital Control has 8 other known error codes, including: E1 (Internal Drive Fault), FLOW (No Flow Detected), MECH-01 (Mechanical Seal Leak), MECH-02 (Motor Bearing Noise), MECH-03 (Impeller Clog or Debris), and 3 more.

Error code CE also appears on 4 other Jandy models: JXi 260 260,000 BTU Pool Heater with High Efficiency and Digital Temperature Control, JXi 400,000 BTU Pool and Spa Heater with Digital Temperature Control, LXi 400,000 BTU Low NOx Pool and Spa Heater, VS FloPro 1.85 THP Variable Speed Pool Pump. The fix may vary by model, so check each model's specific page for tailored repair steps.