MECH-10
Hotpoint · HSS25GFTWW 25.3 cu ft Side-by-Side Refrigerator with Ice & Water Dispenser and LED Interior Lighting
No water comes from the door-mounted water dispenser — the most common cause on Hotpoint side-by-side refrigerators is a frozen water reservoir inside the refrigerator door; this occurs when the fresh food section is set too cold (below 33°F); the internal water tube can also freeze; set the refrigerator temperature to 37°F and wait 24 hours for the ice to thaw; other causes include a clogged water filter (replace every 6 months), a failed water inlet valve (located behind the refrigerator at the bottom — test solenoid coils for continuity and check for 120VAC during dispense), a kinked water supply line, or a faulty dispenser switch on the door
Error MECH-10 on the Hotpoint HSS25GFTWW 25.3 cu ft Side-by-Side Refrigerator with Ice & Water Dispenser and LED Interior Lighting means: Water Dispenser Not Working. The top-ranked community fix is “Test and Replace Water Inlet Valve and Dispenser Switch” (hard difficulty, ~90 min, DIY cost: $20-$40). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · refrigerator
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many refrigerator repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $180-$300.
Not Cooling — Compressor Won't Run
Frost/Ice Buildup in Freezer — Defrost Failure
Water Leaking Inside or Onto Floor
Loud Humming, Buzzing, or Clicking Noise
Runs Constantly — Never Shuts Off
Freezer Cold but Fresh Food Section Too Warm
Too Cold — Freezing Food in Refrigerator Section
Interior Light Not Working
The Hotpoint HSS25GFTWW 25.3 cu ft Side-by-Side Refrigerator with Ice & Water Dispenser and LED Interior Lighting has 8 other known error codes:
Error code MECH-10 also appears on 1 other Hotpoint model:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx