BLINK-7
GE · GDT226SSLSS 24 in Built-In Dishwasher with Piranha Disposal
In diagnostic mode, seven blinks of the Start/Reset LED indicate the heating element has failed — the heating element in the bottom of the tub is used for water heating (to boost temperature) and drying; test the element for continuity with a multimeter (should read 15-30 ohms); a failed element means dishes won't dry properly and sanitize cycles won't reach the required temperature; replacement is accessible from under the dishwasher
Error BLINK-7 on the GE GDT226SSLSS 24 in Built-In Dishwasher with Piranha Disposal means: Start Light Blinks Seven Times — Heating Element Fault. The top-ranked community fix is “Test and Replace the Heating Element” (medium difficulty, ~60 min, DIY cost: $20-$40). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · dishwasher
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many dishwasher repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $180-$280.
dishwasher · 2 fixes
dishwasher · 2 fixes
dishwasher · 2 fixes
dishwasher · 2 fixes
dishwasher · 2 fixes
dishwasher · 2 fixes
dishwasher · 2 fixes
dishwasher · 2 fixes
Single Beep + Flash — Water Fill Issue
Two Beeps — Door Not Latched
Three Beeps — Water Temperature Issue
Start/Reset Light Flashing — Cycle Interrupted
All Indicator Lights On But No Response
Service Code — Fill Valve Stuck Open
Service Code — Fill Valve Stuck Closed
Service Code — Wash Pump Issue
The GE GDT226SSLSS 24 in Built-In Dishwasher with Piranha Disposal has 8 other known error codes:
Error code BLINK-7 also appears on 8 other GE models:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx