Frigidaire GLTE2940FS 5.8 cu ft Gallery Electric Dryer E68 Error Fix: Stuck Heater Relay — Safety Shutdown

Error code E68 on the Frigidaire GLTE2940FS 5.8 cu ft Gallery Electric Dryer means: Stuck Heater Relay — Safety Shutdown. The control board has performed a safety shutdown due to detecting a stuck heater relay. This is the final escalation of the E62/E66 condition. The dryer will not operate until the control board is replaced. Disconnect power. This is a fire safety code — do not attempt to bypass. Replace the main control board after verifying the heating element has no shorts to ground.

The most successful fix is "Replace Main Control Board After Verifying Heating Element" (hard difficulty, ~60 minutes). Estimated DIY cost: $15-$25. HomeMD has 2 community-ranked fixes for this error.

This error is rated critical severity. It is generally not urgent and can often be resolved with a simple DIY fix.

Yes — the top-ranked community fix ("Replace Main Control Board After Verifying Heating Element") is rated hard difficulty and takes about 60 minutes. Tools needed: T20 Torx screwdriver, Multimeter, Needle-nose pliers.

DIY cost: $15-$25. Professional repair typically costs $250-$350. Many homeowners save money by trying the top-ranked community fix first.

The Frigidaire GLTE2940FS 5.8 cu ft Gallery Electric Dryer has 8 other known error codes, including: E4A (Inlet Thermistor Open or Shorted), E4B (Outlet Thermistor Open or Shorted), E5B (Door Switch Open — Door Not Closed), E5C (Motor Start Failure), E61 (Heater Relay Not Closing), and 3 more.

Error code E68 also appears on 5 other Frigidaire models: FCED4900HW 8.0 cu ft Electric Dryer with Quick Dry, FCGD4900HW 8.0 cu ft Gas Dryer with Quick Dry, FFRE4120SW 7.0 cu ft Electric Dryer with Wrinkle Shield and Sensor Dry, FFRE4120SW2 6.7 cu ft Front Load Electric Dryer, FFRG4120SW 6.7 cu ft Front Load Gas Dryer. The fix may vary by model, so check each model's specific page for tailored repair steps.