F3
Dacor · HWO230PS Heritage Wall Oven
The oven temperature sensor (RTD — Resistance Temperature Detector) has a shorted circuit. The sensor resistance is reading too low (near zero ohms), indicating a short in the sensor element or its wiring. Check the sensor harness and connection between the oven sensor and the oven control board. Measure the sensor resistance — at room temperature (75°F), it should read approximately 1080-1100 ohms. If the reading is very low or zero, replace the RTD sensor. Also check the wiring for damaged insulation causing a short to ground.
Error F3 on the Dacor HWO230PS Heritage Wall Oven means: Shorted Oven Temperature Sensor (RTD). The top-ranked community fix is “Replace Shorted Oven Temperature Sensor (RTD) and Inspect Wiring” (medium difficulty, ~45 min, DIY cost: $20-$30). 2 community-ranked fixes available below.
Published February 2026 · 2 fixes · oven
Content is based on manufacturer service documentation, community repair experience, and OEM technical bulletins. Always verify with your owner's manual.Learn about our editorial standards.
While many oven repairs can be done safely at home, consider hiring a qualified technician if:
Average professional repair cost for this issue: $150-$220.
microwave · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
oven · 2 fixes
Function Key Stuck
System Watchdog Circuit Fault
Heating Mode Over-Temperature
Open Oven Temperature Sensor (RTD)
Door Lock Enabled Above Temperature
Door Locking Switch Fault
Convection Fan Motor Noise or Failure
Oven Door Gasket Worn or Deteriorated
The Dacor HWO230PS Heritage Wall Oven has 8 other known error codes:
Error code F3 also appears on 6 other Dacor models:
Ad Space — banner
Replace ADSENSE_PUBLISHER_ID in AdUnit.tsx